Where can I locate the users manual for the Cisco Explorer HDC DVR? I’m been unable to locate any documentation or support resources for this DVR on. Cisco HDC Cable DVR T : Industrial & Scientific. I can’t seem to get my harmony elite to control my DVR–time warner Cisco Ive placed HUB all over including right next to it and it does.
|Published (Last):||5 April 2007|
|PDF File Size:||18.27 Mb|
|ePub File Size:||3.1 Mb|
|Price:||Free* [*Free Regsitration Required]|
Its a bandwidth saving feature we enabled. TWC did include the 4: From what you describe it sounds like there might be something wrong with the internal hard drive. Both Cisco and Samsung boxes are capable of HD graphics.
Do you know of a way to control the brightness of the display of this box? Thanks for your help. I connected the ethernet port on my cable box to a linksys switch and I was able to obtain link.
Everything I try to look at it with says it is unrecognized. I have a total of four boxes in the house; two non-dvr; two dvr. For information, my other boxes all worked fine. Or you can reboot the box by unplugging the power for 30 seconds and then rebooting it. I had another problem that the TW technician confirmed to me.
It then finished and the on-demand movie played. I hope this is curable. Our Holiday viewing was a nightmare. Disk space says the DVR is pretty much empty, yet there are a ton of shows still listed as saved, but will not play.
It is located just to the right of the USB port. I have a Cisco and would like to know about the filesystem. Forbidden — access allowed only on return path interface. We have the box in our bedroom and it is too bright. Cieco have been two mentions in the thread regarding random channel switching ccisco reboots.
I also lost Dolby 5.
I only have problems with the hdc, it stop working last week it was replaced with a new one, after it downloaded a software refresh the channel it defaults to is a non HD channel going to a HD channel made the TV connected via a HDMI cable to make a very loud noise and stop working, it burned the mobo on the TV I need help. Said guide update is causing the sluggish response time between the remote and the cable box.
Taking a Look Inside the Cisco 8742HDC Cable Box
Since upgrading to thethe response time in the guide is immediate. I had the tech come out to look into my picture quality issues and check the signal quality.
Of note, this lately was not the case with my swapped-out samsung. It is necessary to kill the power for a reboot about every days. Unfortunately at this time the best option seems to be turning off the clock all together. Using a watts up power meter I measured an actual draw of about 20 watts while the DVR was powered up. This iit is also normal if you here weird noises come from this box at nights.
Hi sorry I jumped the 7842, I was plugging the composite cable into the wrong input. Silly mistake ciscco my part. A bad node was found once after years of issues and found out a lot of people were complaining, just not 3 within 10 minutes.
It takes 24 hours before caller ID starts appearing on the box. Thanks for all your research on this box. However, I have two, and if you connect them together with a switch router then they will be able to see each other. I think I will also run an IR blaster to receiver to have it on and muted when I remote in to the slingbox.
Users manual for Explorer HDC DVR – Cisco Community
All TWC divisions will deploy this guide at one point or another, so it is coming. I connected them via their ethernet ports. Thanks for all of the useful info. Techs have no clue and none have been dispatched to residence since March when the was swapped out.
At an earlier time, I had 874 same issue with the samsung, but it spontaneously resolved. Go to 32 your page may be different. I have the exact same problem as Ray, above.
The usually happen on Tuesday mornings 1: In my area they rebooting the boxes every 2 weeks from the main office as they have found this to be a temporary fix. TWC tech helped to try and locate such settings but we could not find one. Can I swap the wd internal drive with a seagate 2tb had drive from a purchased hopper with sling dvr? Today it quit on me while recording a show 14 minutes in.
I purchased an IR extender as suggestedand plugged it into the IR port in the back of the box. On the old cable box I had the same problem BUT the old box had not only a fiber optic cable for sound but a digital coax cable RCA type jack so I was able to run fiber from TV to Bose and then run the digital coax cable from Bose to back of cable box.
I previously posted Has anyone had this issue and does anyone know how to fix? Please help if you can.
TWC sent it to replace my old Scientific Atlanta box that was having a myriad of problems.